Ibratjon Aliyev – All sciences. №5, 2023. International Scientific Journal (страница 2)
Аннотация. Радиация во всех её проявлениях является неотъемлемой частью всей ядерной промышленности, наряду с прочими её действиями на ускорителях заряженных частиц, а также в повседневной жизни, при учёте общей фоновой радиации, либо при поиске радиоактивных ископаемых, коих достаточно много. И при этом важно масштабирование этого процесса с использованием большего количества оборудований, однако, для достижения поставленных целей, необходимо организовывать благоприятную почву в лице более доступных дозиметров, как примера одного из типов оборудования на основе плат Arduino.
Ключевые слова: радиация, дозиметр, Arduino, определение, радиоактивный фон, определение и констатация данных измерительных приборов, измерительные приборы.
As you know, there are several types of radiation: alpha, beta and gamma, which are almost always found together in nature. And it is possible to create meter designs for each type of radiation, therefore in this model the type of dosimeter for the determination of beta radiation will be considered. To do this, a small beta Geiger counter with a mica window will be used, from where all types of radioactive radiation pass. After that, a special printed circuit board is created based on the Arduino Pro Mini and a 128 by 32 pixel OLED display, and a TP4056 battery is installed under the module. The MT3608 boost module is located under the board itself, to increase the voltage from the battery to 5 V. After printing the board, it was time to use a special library, of which there were enough types.
In one of the tested libraries, it was possible to observe slowness in operation, in others indistinct indicators on a small display, etc., as a result of such a sample, the resulting type of library GyverOLED and GyverButton, operating at a frequency of 80 kHz, was determined. When the circuit was assembled, experimental launches were made, however, they showed that the step-up module led to a rapid burnout of a large number of parts, including the Arduino board itself, which caused it to be replaced with an auto generator with a stable voltage with a throttle and two windings – a surface one for 3 turns and a step-down one for 5 turns. Also, an MPM transistor of type 13003 or KT815 is used for grounding.
Fig. 1. Diagram of the dosimeter device on Arduino Pro Mini
As a result, the circuit of the device looked like in Fig. 1., while the resistor data (marked with an asterisk) had to be selected to increase the accuracy of the device, which could be seen when connected to an oscilloscope, using a 100 kOhm resistor is sufficient for low accuracy. And the diode (also marked with an asterisk) is necessary for the input voltage drop for the autotransformer, since depending on the input voltage, the output voltage is obtained, the value of which should be an increase of the order of 350-400 V.
Next, a case was created that fits all the necessary parts on a 3D printer with battery compartments, a boozer or speaker that goes to the front panel, the front panel itself, buttons, the board itself, and so on. Finally, the device was turned on and tested.
The display showed data on the loading of values (on the left about the achievement of the maximum accuracy), the radiation value itself, under it the unit of measurement is mkR / h, then next to the mode – alpha, beta, gamma, alpha + beta, beta + gamma, alpha + gamma or alpha + beta + gamma. There was also a radiation icon nearby, indicating the arrival of a charged particle of one type or another, and next to it was the battery charge level.
2 buttons are organized for control. Pressing the first of them leads to the display of the dose value of the radiation received from the moment the dosimeter is turned on. Pressing again returns to the main screen. A long press of the first button resets the readings and repeats the analysis, which leads to the zeroing of the "readiness indicator" that was on the left on the main panel. Double-clicking changes the unit of measurement to mSv/h, and the dose reading will also be in these units.
The lower button, when pressed once, shows the maximum dose of radiation received. When pressed twice, the search mode starts every second, however, these values have low accuracy, however, this mode signals well about the presence of any radiation sources, even with relatively low radiation. In addition, it is worth saying that with an increased radiation background, the accuracy may drop, but the counting speed increases dramatically for faster signaling for the user.
Testing The device was also tested using uranium glass and professional sensors, the data of which practically coincided during measurements and the difference in values was no more than hundredths of an mP/h. Some other sources were also used, during testing of which, the data again coincided.
As a result, a device was created that allows determining the level of background radiation with sufficient accuracy for practical use using Arduino.
Used literature
1. Histo-hematic barriers and ionizing radiation: monogr.. – M.: Publishing House of the Academy of Sciences of the USSR, 2013. – 216 p.
2. Dielectrics and radiation. In 4 books. Book 1. Radiation electrical conductivity / N. S. Kostyukov et al. – L.: Nauka, 2012. – 256 p.
3. Dielectrics and radiation. In 4 books. Book 3. Mechanical and electrical strength and structure change under irradiation / N. S. Kostyukov et al. – L.: Nauka, 2015. – 256 p.
4. Dielectrics and radiation. In 8 books. Book 7. The influence of transmutants on the properties of ceramic dielectrics: monograph / N. S. Kostyukov et al. – L.: Nauka, 2015. – 280 p.
5. Egorov, A. P. Hematopoiesis and ionizing radiation: monograph / A. P. Egorov, V. V. Bochkarev. – M.: State Publishing House of Medical Literature, 2012. – 256 p.
6. Li, D. E. The effect of radiation on living cells / D. E. Li. – M.: State Publishing House of Literature on Atomic Energy science and Technology of the State Committee of the Council of Ministers of the USSR on the Use of Atomic Energy, 2014. – 288 p.
7. Livanov, M. N. Some problems of the effect of ionizing radiation on the nervous system: monograph / M. N. Livanov. – M.: State Publishing House of Medical Literature, 2013. – 196 p.
8. Nadareishvili, K. Sh. Questions of the influence of ionizing radiation on the cardiovascular system / K. Sh. Nadareishvili. – M.: Metsniereba, 2011. – 300 p.
9. Nikolay, Daineko und Sergey Timofeev Radiation and medicinal plants / Nikolay Daineko und Sergey Timofeev. – M.: LAP Lambert Academic Publishing, 2014. – 156 p.
10. Pobedinsky, M. N. Methods of examination of the function of the genital glands in women working with sources of ionizing radiation / M. N. Pobedinsky. – M.: State Publishing House of Medical Literature, 2014. – 28 p.
11. Smirnova, O. A. Radiation and the mammalian organism. Model approach: monogr. / O. A. Smirnova. – M.: SIC "Regular and chaotic dynamics", Institute of Computer Research, 2010. – 224 p.
12. Teldeshi, Yu. Radiation – threat or hope / Yu. Teldeshi, M. Kenda. – M.: Mir, 2011. – 415 p.
13. Hall, J. Radiation and life / J. Hall. – L.: Medicine, 2014. – 256 p.
14. Shlyakhov, V. Investigation of the balance of long-wave radiation in the troposphere: monograph / V. Shlyakhov. – M.: Hydrometeorological Publishing House, 2014. – 82 p.
15. Shubik, V. M. Life with radiation. Book 1. Peaceful atom: benefit – harm: monogr. / V. M. Shubik. – M.: SINTEG, 2011. – 212 p.
TECHNICAL SCIENCES
ALARM SENSOR FOR GEOTHERMAL ENERGY FACILITIES
UDC 620.97
Qo’ldashov Obbozjon Xokimovich
Doctor of Physical and Mathematical Sciences, Professor of the Scientific Research Institute "Physics of Semiconductors and Microelectronics" at the National University of Uzbekistan
Scientific Research Institute "Physics of Semiconductors and Microelectronics" at the National University of Uzbekistan
Komilov Abdullajon Odiljonovich
Assistant of the Fergana branch of the Tashkent University of Information Technologies
Ferghana Branch of Tashkent University of Information Technologies
Jumaev Javohir Abdurasulovich
2nd year student of the Department of 13.03.02 "Electric power and electrical engineering" of the Tashkent branch of the Moscow Power Engineering Institute
Tashkent Branch of the Moscow Power Engineering Institute
Annotation. Over the past decades, there has been an increased interest in alternative sources of renewable energy in nature: solar, geothermal, wind, etc. It should be noted that this interest is caused not only because of the annual increase in prices for traditional fuels (oil, coal, gas) and forecast data on the depletion of their reserves in the foreseeable future. It is also caused by the need to address issues of environmental protection from pollution and possible man-made disasters. For these reasons, many countries around the world are focused on a rational combination of traditional energy sources with renewable ones. At the same time, among renewable energy sources, the deep heat of the Earth occupies not the last place. It is enough to name countries such as Iceland, the Philippines, New Zealand, Indonesia, the USA, Italy, etc., where there are enormous thermal resources lying in relatively shallow layers of the earth’s crust.